It is used to break the loop of Test Case.
It is used to call user-defined Methods (Group of Test Steps clubbed for re-usage or repetitive execution).
The methods can be parameterized according to the user requirements. The user can also call a method from a different file on the local machine or a remote file path, and utilize them
|Selecting a Call Method step and pressing F3 would open up the respective method|
It allows users to immediately jump to the next iteration of the loop.
It allows users to exit from the current Test Case/Test Suite/Test Project.
It allows users to exit from a Test Case and switch to the next consecutive Test Case.
It allows users to exit from a Test Project and switch to the next consecutive Test Project.
It allows users to exit from a Test Suite and switch to the next consecutive Test Suite.
It allows users to introduce a user-defined failure of a Test Step/Test Case on some condition evaluation of a test case. Users can define their own failure statement in the Value column of the Fail test command.
It allows users to End a forking process.
It allows users to Start a forking process.
It allows users to stop a defined loop of test steps after achieving a particular result.
It allows users to start a defined loop of test steps to achieve a particular result. To start execution of a loop, the user needs to configure it using Data table.
It allows users to execute the MS-DOS Commands.
It allows users to execute Linux based commands to FTP Server.
|It will store Result in Target Variable.|
It allows users to stop a While loop.
It allows users to start a While Loop. To execute this loop, the user has to mention the condition
|If step By is blank, it will step by 1 position depending on operator selection.|
It allows users to write a particular message on the console and report window.
It allows users to Write Source Variables into Target Data Table.